Peugeot 2008: Lighting and visibility / Headlamp beam height adjustment

Peugeot 2008 2019-2026 Owner's Manual / Lighting and visibility / Headlamp beam height adjustment

Manually adjusting the halogen or LED technology headlamps

Peugeot 2008. Headlamp beam height adjustment

To avoid dazzling other road users, the height of these headlamp beams should be adjusted according to the load in the vehicle.

0 (Initial setting)

Driver only or driver + front passenger

1 5 people

2 5 people + load in the boot

3 Driver only + load in the boot

4 5 6 Not used

This information is provided as a guide only.

Depending on version, the unused positions may be required.

Automatic adjustment of the Full LED technology headlamps

This system automatically adjusts the height of the headlamp beams according to the load in the vehicle.

Peugeot 2008. Headlamp beam height adjustment In the event of a malfunction, this warning lamp comes on on the instrument panel, accompanied by the display of a message and an audible signal.

The system then places the headlamp beams in the lowest position.

Have the system checked by a PEUGEOT dealer or a qualified workshop.

Do not touch the LED or Full LED technology headlamps - risk of electrocution!

Direction indicators

Left or right: lower or raise the lighting control stalk, beyond the point of resistance. If you forget to cancel the direction indicators for more than 20 seconds, the volume of the audible signal will increase if the speed is above 50 mph (80 km/h)...

Automatic illumination of headlamps

When the ring is at the "AUTO" position and a low level of ambient light is detected by the rain/sunshine sensor, the number plate lamps, sidelamps and dipped beam headlamps are switched on automatically, without any action on the part of the driver...

Other information:

Peugeot 2008 2019-2026 Owner's Manual: Tool kit

Set of tools supplied with the vehicle. Its content depends on your vehicle's equipment: Temporary puncture repair kit. Spare wheel. Access to the tools Depending on version, the tool kit is stored in a bag or in a storage box in the boot. On the boot carpet or floor Under the boot carpet or floor Raise the boot floor (depending on version), then the boot carpet by pulling the strap to ..

Peugeot 2008 2019-2026 Owner's Manual: Power indicator (Electric)

CHARGE Traction battery charging during deceleration and braking. ECO Moderate energy consumption and optimised driving range. POWER Energy consumption by the drive train during acceleration. NEUTRAL On switching on the ignition, your vehicle’s electric drive train neither consumes nor generates energy: after sweeping over the indicator, the needle or the cursor returns to its "neutral" posit..

Energy economy mode

This system manages the duration of use of certain functions, in order to conserve a sufficient level of charge in the battery with the ignition off.

After switching off the engine, you can still use functions such as the audio and telematic system, the wipers and the dipped beam headlamps or courtesy lamps, for a combined duration of approximately 40 minutes.

Selecting the mode

A confirmation message is displayed when energy economy mode is entered, and the active functions are placed on standby.

Peugeot 2008. Energy economy mode If a telephone call is in progress at the time, it will be maintained for around 10 minutes via the audio system’s hands-free system.