Peugeot 2008: Practical information / Free-wheeling
In certain situations, you must allow the vehicle to free-wheel (while being towed, on a rolling road, in an automatic car wash, or being transported by rail or sea freight, etc.).
The procedure varies according to the type of gearbox and parking brake.
With manual or EAT6 automatic gearbox and electric parking brake
Release procedure
- With the engine running and while depressing the brake pedal, move the gear selector to the neutral position.
- While depressing the brake pedal, switch off the ignition.
- Release the brake pedal, then switch on the ignition again.
- While depressing the brake pedal, press the control lever to release the parking brake.
- Release the brake pedal, then switch off the ignition.
Reverting to normal operation
- While depressing the brake pedal, start the engine.
With EAT8 automatic gearbox and manual parking brake
Release procedure
- With the vehicle stationary and the engine running, select mode N and switch off the ignition.
Within 5 seconds:
- Switch on the ignition again.
- While depressing the brake pedal, move the push selector forwards or backwards to confirm mode N.
- Switch off the ignition.
- If the 5-second time limit is exceeded, the gearbox engages mode P; it is then necessary to restart the procedure.
Reverting to normal operation
- Press button P on the selector.
With EAT8 automatic gearbox or drive selector and electric parking brake
Release procedure
- With the vehicle stationary and the engine running, select mode N and switch off the ignition.
Within 5 seconds:
- Switch on the ignition again.
- While depressing the brake pedal, move the push selector forwards or backwards to confirm mode N.
- While depressing the brake pedal, press the control lever to release the parking brake.
- Release the brake pedal, switch off the ignition.
If the 5-second time limit is exceeded, the gearbox engages mode P; it is then necessary to restart the procedure.
Reverting to normal operation
- While depressing the brake pedal, restart the engine.
Keyless Entry and
Starting
You must not depress the brake pedal while switching the ignition on or off. If you do, the engine will start, requiring you to restart the procedure.
AdBlue® (BlueHDi)
To respect the environment and ensure compliance with the Euro 6 standard,
without adversely affecting the performance or fuel consumption of its Diesel
engines, PEUGEOT has taken the decision to equip its vehicles with a system that
associates SCR (Selective Catalytic Reduction) with a Diesel Particle Filter (DPF)
for the treatment of exhaust gases...
Advice on care and maintenance
General recommendations
Observe the following recommendations to avoid damaging the vehicle.
Exterior
Never
use a high-pressure jet wash in the engine compartment - risk of damaging the
electrical components!
Do not wash the vehicle in bright sunshine or extremely cold
conditions...
Other information:
Peugeot 2008 2019-2025 Owner's Manual: Automatic illumination of headlamps
When the ring is at the "AUTO" position and a low level of ambient light is detected by the rain/sunshine sensor, the number plate lamps, sidelamps and dipped beam headlamps are switched on automatically, without any action on the part of the driver...
Peugeot 2008 2019-2025 Owner's Manual: Media
USB port Insert the USB memory stick into the USB port or connect the USB device to the USB port using a suitable cable (not supplied). To protect the system, do not use a USB hub. The system builds playlists (in temporary memory); this operation can take from a few seconds to several minutes at the first connection...
Categories
- Manuals Home
- 2nd Generation Peugeot 2008 Owners Manual
- 2nd Generation Peugeot 2008 Service Manual
- Locking the vehicle
- Proximity Keyless Entry and Start
- Active Safety Brake with Distance Alert and Intelligent emergency braking assistance
- New on site
- Most important about car
Courtesy lamps. Interior ambience lighting
Courtesy lamps
Non touch-sensitive version
